USG Flex 200 - Detecting APs on DMZ interface
Options
Hello,
I have a USG Flex 200 firewall which I just installed and configured. Everything is great however I would like to manage my three APs WA510Ds via the USG firewall. Preferred I would like to add the APs to my DMZ network however when I give the APs an IMP in the DMZ they are not getting detected. If I give them an IP within the LAN network then they show up in the firewall. Is there a way I can enable the AP detection on the DMZ interface as well?
Thank you
Marcus
I have a USG Flex 200 firewall which I just installed and configured. Everything is great however I would like to manage my three APs WA510Ds via the USG firewall. Preferred I would like to add the APs to my DMZ network however when I give the APs an IMP in the DMZ they are not getting detected. If I give them an IP within the LAN network then they show up in the firewall. Is there a way I can enable the AP detection on the DMZ interface as well?
Thank you
Marcus
0
All Replies
-
You need to make a from DMZ to Zywall rule I think for ports UDP 2018 and 5246
0 -
Hello PeterUK, that worked. Thank you very much0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 79 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 909 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight