USG Flex 200 - Detecting APs on DMZ interface
Options
Freshman Member
Hello,
I have a USG Flex 200 firewall which I just installed and configured. Everything is great however I would like to manage my three APs WA510Ds via the USG firewall. Preferred I would like to add the APs to my DMZ network however when I give the APs an IMP in the DMZ they are not getting detected. If I give them an IP within the LAN network then they show up in the firewall. Is there a way I can enable the AP detection on the DMZ interface as well?
Thank you
Marcus
I have a USG Flex 200 firewall which I just installed and configured. Everything is great however I would like to manage my three APs WA510Ds via the USG firewall. Preferred I would like to add the APs to my DMZ network however when I give the APs an IMP in the DMZ they are not getting detected. If I give them an IP within the LAN network then they show up in the firewall. Is there a way I can enable the AP detection on the DMZ interface as well?
Thank you
Marcus
0
All Replies
-
You need to make a from DMZ to Zywall rule I think for ports UDP 2018 and 5246
0 -
Hello PeterUK, that worked. Thank you very much0
Guru Member
Categories
- All Categories
- 442 Beta Program
- 3K Nebula
- 228 Nebula Ideas
- 130 Nebula Status and Incidents
- 6.6K Security
- 647 USG FLEX H Series
- 357 Security Ideas
- 1.8K Switch
- 86 Switch Ideas
- 1.4K Wireless
- 55 Wireless Ideas
- 7.1K Consumer Product
- 304 Service & License
- 496 News and Release
- 93 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 5K FAQ
- 34 Documents
- 89 About Community
- 110 Security Highlight
