ZywallATP100 keeps booting
CharlyBrown
Posts: 4
in Security
In the last days the network appeared being slow, despite the router being up to speed. Therefore, rebooted the Zywall. Now, it doesn't startup correctly anymore and cannot be reached.
LEDS:
PWR: constant green
SYS: blinking green (for 2 hours or so)
Ports: all off
LEDS:
PWR: constant green
SYS: blinking green (for 2 hours or so)
Ports: all off
Last active FW: 5.00
Looking forward to your guidance. Thx
0
All Replies
-
Tried a hard reset - but that didn't have any effect either. Therefore, have sent it now to the technical service point of Zyxel. Let's see what they say.
0 -
I have the same problem!
did you get an answer?
0 -
@Davide_CUD - No, not yet. The device is on its way to the manufacturer. Knowing that someone is interested in the outcome, I'll post the result here hopefully next week.
0 -
You need to update the firmware, see the following post:
0 -
@Mario Thank you for that hint - however, if the Zywall device doesn't startup any more and cannot be reset, then I would not know how to patch the firmware...
0 -
Hello @CharlyBrown, @Davide_CUD,
If your device was suffering device hang after reboot, please refer to these article to recover the device.
Thanks!
James.
0
Ally Member
Zyxel Employee
Categories
- All Categories
- 431 Beta Program
- 2.6K Nebula
- 164 Nebula Ideas
- 112 Nebula Status and Incidents
- 6K Security
- 364 USG FLEX H Series
- 292 Security Ideas
- 1.5K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 42 Wireless Ideas
- 6.6K Consumer Product
- 262 Service & License
- 407 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.9K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight
