NWA210AX and Cisco POE Switch
barmalej
Posts: 1
I have 2 NWA210AX connected to Cisco C3650-12X48UQ POE switch. In Nebula portal the power mode shows as limited for both. The switch supports 802.3at.
Here is the POE status of one of the ports:
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Te1/0/37 auto on 15.4 Ieee PD 4 60.0
0
All Replies
-
Hi @barmalej
The power is allocated automatically via negotiations.
Actually, we had some cases of compatibility issues between different vendor devices, even though switch states enough PoE but still can’t provide AP required power.
With this situation, you can feel no worries to force full power to let AP works, and it doesn’t happen unexpected failure.
Force full power is to use software enforce AP services in full antenna status but the power delivering status between PD and PSE is the same so the result is as you mentioned from switch side.
If you require any further information, feel free to contact us.
Thank you
Regards,
Bella
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight