XS1930-10 as a L3 WAN Router?
Options
The XS1930-10 seems to have the full capabilities of a L2 and L3 router, it even has a DHCP relay. However, I cannot figure out how to configure a port as NAT and route accordingly. Is there a basic guide to setting this up properly for one port to act as an IPV4 NAT to a specific VLAN ?
0
All Replies
-
NAT is done by a router a switch can't NAT many MAC's for a LAN to go out a given WAN IP by a given MAC.
If you make your client have the same MAC (and ideally the same the DHCP requests) you can (works on my GS2210) use VLAN to make the switch like a hub and not conflict their being the same MAC this does mean the clients are isolated.
0 -
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 74 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 333 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 886 Nebula FAQ
- 415 Security FAQ
- 228 Switch FAQ
- 198 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight