Issue with VPN Connecting to Internal Devices from WAN Failover to LAN1
Options
All Replies
-
PeterUK said:
So that will be L2TP over IPSec? Can you check the setting in the made VPN for windows has “use default gateway on remote network” checked.
Control Panel\Network and Internet\Network Connections
0 -
Yes client can connect fine but if the option is not checked then it will not work.
Also check a zone is set for the VPN on zywall
0 -
dcgtechnologies said:The error in logs is below:
Match default rule, DNAT Packet, DROP [count=2] - 166.x.x.x 192.x.x.x - Access Block0 -
Another thing is if you enable for routing"Use IPv4 Policy Route to Overwrite Direct Route"0
-
PeterUK said:
Yes client can connect fine but if the option is not checked then it will not work.
Also check a zone is set for the VPN on zywall
0 -
PeterUK said:dcgtechnologies said:The error in logs is below:
Match default rule, DNAT Packet, DROP [count=2] - 166.x.x.x 192.x.x.x - Access Block0 -
So I fixed it. It turns out under "VPN Connection". The checkbox next to "Use Policy Route to control dynamic IPSec rules" was checked. I unchecked it and everything started working as usual. That was causing all the traffic to be blocked. Thank you for help and sorry for the confusion.0
-
dcgtechnologies said:What are the parameters for the zone that needs to be set? Thank you.
0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 79 Nebula Status and Incidents
- 5.1K Security
- 73 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 886 Nebula FAQ
- 415 Security FAQ
- 228 Switch FAQ
- 198 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 63 Security Highlight