vlan
Options
Accepted Solution
-
Hello @baudetd,Welcome to Zyxel community.As @PeterUK suggested, please go to Configuration > Security Policy > Policy Control, and edit LAN2_Outgoing policy, change the "To:" option to from Any to WAN. This change will allow the LAN2 to communicate with the internet and not other internal interfaces.Thank you.James0
All Replies
-
Ok you mean lan2 (p4) then you need to make sure policy control from LAN2 is set to WAN not any.
0 -
Hello @baudetd,Welcome to Zyxel community.As @PeterUK suggested, please go to Configuration > Security Policy > Policy Control, and edit LAN2_Outgoing policy, change the "To:" option to from Any to WAN. This change will allow the LAN2 to communicate with the internet and not other internal interfaces.Thank you.James0
-
hi,
ok it's good !
can you tell me more about the différent pages (,is there a doc?
how could you also limit the flow on lan2 ?
version firmware is 4.35 , it's time to update!
0 -
Hello @baudetd,Do you mean BWM(Bandwidth Management)?Please go to Configuration > BWM, enable BWM and create a profile for LAN2 interface. Select lan2 as Incoming Interface and LAN2_subnet as Source, then customize the limitation such as bandwidth Shaping.You may refer to our knowledge base articles or handbook page 788 for more.James0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 77 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight