Connect clients on LAN 1 to server on LAN 2
All Replies
-
Hi @PeterUK,
You rock! I forgot it is typical triangle route in this scenario.
Thanks for highlighting the mistake.
0 -
Thinking about it to not have “Allow Asymmetrical Route” checked on the USG60 a better option for that setup is to use “Use IPv4 Policy Route to Overwrite Direct Route” on the USG40 with this routing rule.Again this would be usefulUSG40 routing ruleincoming interfacemember LAN2destination 192.168.147.0/24next hoptype gatewaygateway IP of LAN1 gateway on UDG60SNAT none1
Zyxel Employee
Guru Member
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
