ZyWALL 310 to USG FLEX 500 Migration How to
Afternoon, I see the configuration converter > https://www.zyxel.ch/de/landingpages/usg-configuration-converter
However the route sold is not offered on this.
I have 2 x customers.
Cust A = 1 x Zywall 310 > 1 x USG FLEX 500 (stand alone router)
Cust B = 2 x Zywall 310 in HA PRO > 2 x USG FLEX 500
Can i get some pointers on if / how to perform the migration pls?
0
Accepted Solution
-
Hi @Emerald
The converter will remove all of UTM(security service) setting from configuration, so it will left Interface/ zone settings in converted setting. So you just need to make sure the hardware port amount are the same.
e.g.
ZyWALL 310 <> USG310
USG FLEX 500 <>ATP500 <>VPN300
0
All Replies
-
Hi @Emerald
The converter will remove all of UTM(security service) setting from configuration, so it will left Interface/ zone settings in converted setting. So you just need to make sure the hardware port amount are the same.
e.g.
ZyWALL 310 <> USG310
USG FLEX 500 <>ATP500 <>VPN300
0 -
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 65 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight