ZyWALL 310 to USG FLEX 500 Migration How to
Options
Afternoon, I see the configuration converter > https://www.zyxel.ch/de/landingpages/usg-configuration-converter
However the route sold is not offered on this.
I have 2 x customers.
Cust A = 1 x Zywall 310 > 1 x USG FLEX 500 (stand alone router)
Cust B = 2 x Zywall 310 in HA PRO > 2 x USG FLEX 500
Can i get some pointers on if / how to perform the migration pls?
0
Accepted Solution
-
Hi @Emerald
The converter will remove all of UTM(security service) setting from configuration, so it will left Interface/ zone settings in converted setting. So you just need to make sure the hardware port amount are the same.
e.g.
ZyWALL 310 <> USG310
USG FLEX 500 <>ATP500 <>VPN300
0
All Replies
-
Hi @Emerald
The converter will remove all of UTM(security service) setting from configuration, so it will left Interface/ zone settings in converted setting. So you just need to make sure the hardware port amount are the same.
e.g.
ZyWALL 310 <> USG310
USG FLEX 500 <>ATP500 <>VPN300
0 -
Categories
- All Categories
- 390 Beta Program
- 2.1K Nebula
- 116 Nebula Ideas
- 78 Nebula Status and Incidents
- 5.1K Security
- 51 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 70 Switch Ideas
- 907 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 332 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 880 Nebula FAQ
- 415 Security FAQ
- 220 Switch FAQ
- 195 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 63 Security Highlight