USG Flex 700 WAN Trunk

jayd691
jayd691 Posts: 21  Freshman Member
Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - WLAN Zyxel Certified Network Administrator - Switch Zyxel Certified Network Administrator - Nebula
in Security
I only have one WAN from my ISP and the default trunk contains both ge1 & ge2. I was going to create my own WAN trunk with only ge1 included, but you still need to configure a load balancing protocol.

My concern is a loss of bandwidth I have been experiencing. I have ge2 shut down, but how can I create just one WAN port without a trunk? What is the best load balancing protocol to use if I only have one WAN line in? Or is it best to just use ge3 as my WAN and forgo the trunk altogether?

Accepted Solution

  • Zyxel_James
    Zyxel_James Posts: 663  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate 100 Answers
    Answer ✓
    Hello @jayd691,
    Since you don't have another WAN interface that is active, you can ignore the other WAN interfaces in the default WAN trunk, all the Load Balancing Algorithm types will have the same effect. It's no need to create another WAN trunk with ge3.


    James

All Replies

  • Ian31
    Ian31 Posts: 174  Master Member
    5 Answers First Comment Friend Collector Sixth Anniversary
    Don't care about what the algorithm is for only one interface in the Trunk.

  • Zyxel_James
    Zyxel_James Posts: 663  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate 100 Answers
    Answer ✓
    Hello @jayd691,
    Since you don't have another WAN interface that is active, you can ignore the other WAN interfaces in the default WAN trunk, all the Load Balancing Algorithm types will have the same effect. It's no need to create another WAN trunk with ge3.


    James

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）