Virtual Interface USG 100
Options
In a network with additional public ip addresses, I have installed a usg 110 with static public ip address in WAN1. The configured address is 84.253.177.171/29. The gateway is 84.253.177.169.
I need to publish a local network machine with ip 192.168.1.1 on the internet. I want to configure the usg so that when an http request arrives on address 84.253.177.172 on port 80 it turns it to address 192.168.1.1. I created a virtual interface with ip 84.253.177.172 but the NAt on the local ip doesn't work. Am I preceding correctly? Best regards
0
All Replies
-
Hi @Giuseppe,The port 80 is the default service port for HTTP on USG110. You can either disable HTTP in System > WWW > Service Control > HTTP or set another port for this service port.Besides, you also need to add a security policy rule after NAT rule is created. Go to Security Policy > Policy Control and add a new rule as follows.From: WAN, To: LAN1, Destination: IP address of local network machine, Service: 80, Action: allow0
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 87 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 917 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 916 Nebula FAQ
- 422 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight