NAT from source IP by FQDN
When making a NAT rule for Virtual Server your able to select for source IP a FQDN which would allow a dynamic connection by given FQDN to IP to match the NAT rule.
WILDCARD FQDN are not selectable.
Comments
-
NAT <> Virtual Host.NAT chews only IPs, no hostnames.0
-
You're probably right.
I'll gladly read the lecture, if you will write it when you'll have enough time.0 -
Thanks Peter, do you refer to security policy? It's the only rules where I can specify a source IP as FQDN, but if I set this I can't set the dest. port and I wouldn't that this has effect for all NAT because I have some port forwarding without restriction and other with this source restriction.
Thanks in advance
0 -
The idea is for the NAT rule to have select traffic by source FQDN go to a port like port 80 at say 192.168.0.2 but with another rule below for port 80 to have any other traffic go to 80 192.168.0.80
there is a way you can do the above but needs a VLAN switch and another USG and not with NEBULA
if your not needing that then you can use security policy
0
Categories
- All Categories
- 347 Beta Program
- 2.1K Nebula
- 114 Nebula Ideas
- 77 Nebula Status and Incidents
- 5K Security
- 44 USG FLEX H Series
- 246 Security Ideas
- 1.2K Switch
- 64 Switch Ideas
- 901 WirelessLAN
- 33 WLAN Ideas
- 5.8K Consumer Product
- 204 Service & License
- 326 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.8K FAQ
- 831 Nebula FAQ
- 401 Security FAQ
- 219 Switch FAQ
- 190 WirelessLAN FAQ
- 45 Consumer Product FAQ
- 136 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 71 About Community
- 61 Security Highlight