NWA5123-AC memory leak detected

Sinna
Sinna Posts: 3  Freshman Member
First Comment Fifth Anniversary
edited May 21 in Wireless

It seems like after enabling 802.11k/v in the NXC2500 AP Profile, all NWA5123-AC AP's report the following:

  • Priority: alert
  • Category: system
  • Note: Memcheck
  • Message: Memory leak detected

The message seems to be followed by an augmenting number.

All AP's are running FW 6.10(AAZY.10).

I can't find any information about this behavior, so I post it here.

As I expect a memory leak in the end results in a reboot (due to lack of memory), I'd like to see this fixed.

All Replies

  • Zyxel_Judy
    Zyxel_Judy Posts: 1,498  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula

    Hi @Sinna ,

    We based on the models and steps that you mentioned to reproduce the issue, however there is no log related memory.

    By the way, note that from 2023-01-31, NWA5123-AC’s technical support and RMA service will no longer be supported by Zyxel. Recommend you refer to WAC500 as a replacement.

    For more information, please refer to this EOL link

    Be a community MVP_1920x200.jpg

    Engage in the Community, become an MVP, and win exclusive prizes!

    https://bit.ly/Community_MVP

  • Sinna
    Sinna Posts: 3  Freshman Member
    First Comment Fifth Anniversary

    @Zyxel_Judy: Thanks for getting back so quickly, really appreciated.

    I didn't realize the AP's are already EOL.

    The memory leak messages are not raised immediately after enabling 802.11k/v and it seems to be related to the number of clients that associate with the AP raising the alert.

    In the meanwhile I've disabled 802.11k/v to see if the situation stabilizes.

Categories

Wireless Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）