Help getting vlan working

Options
n00b
n00b Posts: 7
First Anniversary First Comment
edited July 2023 in Security

I have a USG Flex500, firmware V5.37(ABUJ.0) in native mode and I am unable to get a basic VLAN to functioning correctly. I've read countless articles, and watched multiple Zyxel videos, but still can't seem make it work.

The USG500 is connected to a TP Link SG1024DE smart switch. I have tested the switch by putting multiple workstations on the switch with in the same vlan 70 and they can all ping each other. However, I can not seem to make a workstation, ping the firewall nor receive a dhcp address.

I am using P5 on the Zyxel, base IP range 10.0.0.x with VLAN70 of 10.10.70.x. I have swapped the switch from untagged and tagged, but no combination has worked yet. Below is my configuration and layout. Maybe someone can point out what routing I've overlooked.

Any hints would be appreciated.

TP-Link SG1024DE Settings:

Accepted Solution

All Replies

  • Zyxel_Cooldia
    Zyxel_Cooldia Posts: 1,455  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer
    Options

    Hi @n00b ,

    Assume switch port 1 is a uplink port to flex. port 1-24 should assign to vlan 70

    port 2-24 set to untag, and set pvid 70 on port 2-24

  • n00b
    n00b Posts: 7
    First Anniversary First Comment
    Options

    Thank you for the assistance. I believe I was overthinking it.

    Here is the configuration that work in my TP-Link switch :)

Security Highlight