XS3800-28 jumbo frame
Freshman Member
Hello
I have an XS3800-28 switch with the latest firmware. How can I enable jumbo-frame for use in one of the vlans (vlan for esxi and storage iSCSI traffic).
Accepted Solution
-
Hi @Smartqwerty,
But can i check this in switch web or cli?
» You cannot check the jumbo frame status via web GUI or CLI since it is always enabled.
And what is maximal MTU? I didnt found this in references.
» XS3800 supports 12K jumbo frame for 10G and 9K jumbo frame for 2.5G.
Zyxel Melen0
Zyxel Employee
All Replies
-
-
Hello
But can i check this in switch web or cli?
And what is maximal MTU? I didnt found this in references.0 -
Hi @Smartqwerty,
But can i check this in switch web or cli?
» You cannot check the jumbo frame status via web GUI or CLI since it is always enabled.
And what is maximal MTU? I didnt found this in references.
» XS3800 supports 12K jumbo frame for 10G and 9K jumbo frame for 2.5G.
Zyxel Melen0
Categories
- All Categories
- 439 Beta Program
- 2.8K Nebula
- 202 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.3K Security
- 515 USG FLEX H Series
- 328 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.3K Wireless
- 49 Wireless Ideas
- 6.9K Consumer Product
- 288 Service & License
- 459 News and Release
- 90 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 85 About Community
- 97 Security Highlight
