PLA6457 domain master not being assigned to a local IP address
Hi, I was updating the firmware of the endpoint device (Device B) and I did not know if it would be propagated to the domain master device (Device A), so I went looking for the local IP address of the domain master. Even though I have connected to it before when I was first setting up the device, now I cannot find the IP address of the device anywhere. I have tried running ipconfig and arp -a commands, checking the DHCP lists of both my router and modem, and as a last resort, using the domain master device (Device A) to be my endpoint and the endpoint device (Device B) to be my domain master. However, I always see the MAC address of the initial endpoint device (Device B), and the domain master (Device A) is not listed anywhere. I can see the MAC address listed under the connections in the endpoint device but that's about it. Can anyone help me with this?
Accepted Solution
-
I ran arp -a and the address appeared out of nowhere, the issue can be closed. And apparently, the updates do get propagated.
0
All Replies
-
I ran arp -a and the address appeared out of nowhere, the issue can be closed. And apparently, the updates do get propagated.
0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 924 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 213 Service & License
- 339 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 214 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 74 About Community
- 62 Security Highlight