Router Zyxel EX3301-T0 static IP address for wired device
I did assign a static IP address 192.168.1.3 for a device, with a known MAC address,
which was connected by wire to the router.
That was done via "Home networking" → "Static DHCP".
However, in the page "System" → "ARP Table", the MAC address was bound to a
different IP address. So the static binding did not work.
I also tried to reboot the router, and the device, and even tried to decrease the DHCP
lease time to 2 minutes. But nothing of that helped. The device persistently got the same
IP address, and not the one I had defined.
Interesting though, is that static IP addresses for wireless devices work!
Do you know a solution to this problem with wired devices?
All Replies
-
Hi
Could you please report to your ISP or Zyxel local support?
0 -
Hello @HarryDualBeard
Welcome to the forum.
If you are still having the issue, are you able to say what version of firmware is running in your EX3301-T0 device please?
There was a new version of firmware published in October 2023 that is available for download at https://www.zyxel.com/uk/en-gb/support/download?model=ex3301-t0
Kind regards,
Tony
0 -
Thanks for info.
I suspect that the firmware may be isn't the latest. (It wasn't when I checked it a few weeks ago.)
The ISP is handling the updating. I can't do it myself.
1
Categories
- All Categories
- 397 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 91 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 920 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 210 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 931 Nebula FAQ
- 423 Security FAQ
- 238 Switch FAQ
- 210 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight