MAC address information on NSG

Zyxel_Freda · February 2020

It's an idea from @ComputeInTheCloud that there should be displayed the MAC addresses of all NSG interfaces somewhere on NCC.

mARsIM · November 2023

Have you implemented this feature?

It could also be useuful for ATP and USG.

Zyxel_Melen · November 2023

Hi @mARsIM,

You can check the MAC address information in site-wide > clients. This page displays the clients connected to AP, Switch, and Firewall/Security Gateway.

mARsIM · November 2023

Hi Melen, ok but where i can see others interfaces MAC?

For example, one of our ATP has MAC XX:XX:XX:XX:XX:C2 shown in Client List page but if i check in the ports switch details where it's connected, i can see MAC XX:XX:XX:XX:XX:C4 , XX:XX:XX:XX:XX:C5, XX:XX:XX:XX:XX:C6 and there isn't MAC ending with "C2"

These MAC are not visible under clients list page as you suggested. It's visible only the mac "C2" in that list

It is important know all MAC for example to setup L2 isolation in SSID guest so it should be better display all interfaces mac address in the firewall page or somewhere in the firewall/interfaces page.

Thank you!

Zyxel_Melen · November 2023

Hi @mARsIM,

Thanks for your feedback~
Actually, NSG can check the MAC address of each interface/port on the device detailed page. However, ATP and USG FLEX do not support it. May I know if you hope the Nebula displays each interface's MAC address of ATP/USG FLEX on the device detailed page?

mARsIM · November 2023

Sure Melen, why not?! ;) I think It can be useful for everyone

Zyxel_Melen · December 2023

Hi @mARsIM

Thanks for your feedback. I have created the idea post for you. Here's the link of the idea post:

https://community.zyxel.com/en/discussion/20008/nebula-can-display-the-mac-address-of-all-firewalls-interfaces-ports

mARsIM · December 2023

Great! Thank you Melen

MAC address information on NSG

Comments

Categories

Nebula Tips & Tricks

Nebula Help Center