XGS1930-28 LACP vlan configuration

hades · January 3

How to configure vlans on a LACP port on the XGS1930-28 ? I can't choose a LACP port in the vlan configuration, only the physical ports (1-28) can be selected.

Zyxel_Melen · January 4

Hi @hades,

Please set both the LACP ports as the VLAN's members. For example, if I group ports 7 and 8 as LACP members.

I have to fix ports 7 and 8 as VLAN 10's members.

In addition, please do not set only one port as the VLAN's member. Or the traffic might not be forwarded correctly.

Hope it helps.

Zyxel_Melen · January 4

Hi @hades,

Please set both the LACP ports as the VLAN's members. For example, if I group ports 7 and 8 as LACP members.

I have to fix ports 7 and 8 as VLAN 10's members.

In addition, please do not set only one port as the VLAN's member. Or the traffic might not be forwarded correctly.

Hope it helps.

hades · January 4

Thanks for your reply. This works indeed. However, this is a bad implementation, since this allows for inconsistent configuration :-( A network device should be designed in a way that it should prevent this kind of inconsistency, to keep the possibility of outages in networks to a minimum.

Zyxel_Melen · January 11

Hi @hades,

Thanks for your feedback. I have help you create an idea post and we will monitor for it.

https://community.zyxel.com/en/discussion/20606/make-the-vlan-setting-of-lacp-lag-ports-can-be-synchronized

XGS1930-28 LACP vlan configuration

Accepted Solution

All Replies

Categories

Switch Help Center