wan failover at flex200HP
Accepted Solution
-
wan failover currently can't be done by routeing and should be possible to do ARP failover in trunking.
Make a new User-Defined Trunk add in WAN set one the active the other to Passive
You then may need to make a routing rule for next hop trunk you have made
their is also interface pinging check that you can enable
Edit: testing here shows it working as said above you you need interface pinging check on active WAN when it fails it changes to the Passive WAN then when active WAN is up you switch back for new connections
1
Guru Member
All Replies
-
wan failover currently can't be done by routeing and should be possible to do ARP failover in trunking.
Make a new User-Defined Trunk add in WAN set one the active the other to Passive
You then may need to make a routing rule for next hop trunk you have made
their is also interface pinging check that you can enable
Edit: testing here shows it working as said above you you need interface pinging check on active WAN when it fails it changes to the Passive WAN then when active WAN is up you switch back for new connections
1 -
thnx i am not a it pro so i try to set this. (i dont understand it yet but try to work it out)
0
Categories
- All Categories
- 415 Beta Program
- 2.4K Nebula
- 148 Nebula Ideas
- 96 Nebula Status and Incidents
- 5.7K Security
- 262 USG FLEX H Series
- 271 Security Ideas
- 1.4K Switch
- 74 Switch Ideas
- 1.1K Wireless
- 40 Wireless Ideas
- 6.4K Consumer Product
- 249 Service & License
- 387 News and Release
- 84 Security Advisories
- 29 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.5K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 73 Security Highlight
