Basic configuration. LAN1 -> WAN interface to go online
Best Answers
-
Remove the static route you don't need that.
The enabled default SNAT should of covered this its in network> interface> trunk default WAN trunk > advance
so try this go to network > routing > policy route
add
incoming: interface
please select one member : Lan1
next-hop
type: interface
interface: wan1
address translation
source network address translation: outgoing-interface
6 -
Thanks for the help, I tried to configure it in this way and it works correctly.0
All Replies
-
Remove the static route you don't need that.
The enabled default SNAT should of covered this its in network> interface> trunk default WAN trunk > advance
so try this go to network > routing > policy route
add
incoming: interface
please select one member : Lan1
next-hop
type: interface
interface: wan1
address translation
source network address translation: outgoing-interface
6 -
Thanks for the help, I tried to configure it in this way and it works correctly.0
Categories
- All Categories
- 398 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 83 Nebula Status and Incidents
- 5.2K Security
- 99 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 923 WirelessLAN
- 35 WLAN Ideas
- 5.9K Consumer Product
- 212 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2.1K FAQ
- 1K Nebula FAQ
- 445 Security FAQ
- 238 Switch FAQ
- 213 WirelessLAN FAQ
- 47 Consumer Product FAQ
- 142 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight