uplink currently operates at a lower speed 100 Mbps
Options
JDHaughton
Posts: 2
in Nebula
Hi I've just purchased 2 NWA50AX to vastly improve the wifi in my home/office
- I also purchased an additional 8port POE switch (TL-SG1008p)
I setup the 1st AP, connecting to the above with a new Cat6 cable. It installed fine, and updated. But then a warning was shown in Nebula:
"uplink currently operates at a lower speed 100 Mbps"
So far I have done the following
1. Tested by swapping with different patch cable
2. Tested by rebooting switch/AP with just AP connected
Both gave same results
I then Installed my second NWA50AX to the same switch and did the updates. That switch also gave the same error. I even tried it with the power cable to see if that was the issue - it wasn't.
I then moved the 2nd AP to my Office/Den in a remote part of the house - and connected it. It came up working fine 1st time.
I reads to me that the TP Link switch is the prime-suspect? Any further comment or advice?
Best Regards,
Jon
- I also purchased an additional 8port POE switch (TL-SG1008p)
I setup the 1st AP, connecting to the above with a new Cat6 cable. It installed fine, and updated. But then a warning was shown in Nebula:
"uplink currently operates at a lower speed 100 Mbps"
So far I have done the following
1. Tested by swapping with different patch cable
2. Tested by rebooting switch/AP with just AP connected
Both gave same results
I then Installed my second NWA50AX to the same switch and did the updates. That switch also gave the same error. I even tried it with the power cable to see if that was the issue - it wasn't.
I then moved the 2nd AP to my Office/Den in a remote part of the house - and connected it. It came up working fine 1st time.
I reads to me that the TP Link switch is the prime-suspect? Any further comment or advice?
Best Regards,
Jon
0
All Replies
-
Test with the known good cable at 1Gb with the TL-SG1008p
Are you using ports 1-4 as the uplink with 5-8 PoE+?
0 -
Thanks for thanking time to comment. Ive tested with multiple cables, all the ports and multiple APs. Also with and without the power brick.The only time I got this to work was with a different switch. So going to send the TP link switch back and order a Zyxel one.0
-
There may be a misconfiguration or limitation on the port causing the speed to be limited to 100 Mbps. wordle
0
Categories
- All Categories
- 396 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 81 Nebula Status and Incidents
- 5.1K Security
- 86 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 915 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 211 Service & License
- 337 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 2K FAQ
- 912 Nebula FAQ
- 419 Security FAQ
- 237 Switch FAQ
- 207 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 139 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 72 About Community
- 62 Security Highlight