How do I change standby firmware boot-option

Options
bbp
bbp Posts: 70 image  Ally Member
First Answer First Comment Friend Collector Sixth Anniversary
in USG FLEX H Series

USG Flex 200H - Firmware 1.20(ABWV.2)

1.) How do I change standby firmware boot-option from 0 to 1?
boot-option - Show boot-option, which is used to reboot machine when
backup firmware upgrade successfully. 0:reboot, 1:not
reboot.
There's nothing in CLI Reference Guide for 1.20 firmware on how to change boot-option.

2.) How do I boot into standby firmware?
Also nothing in CLI Reference Guide for 1.20 firmware on how to boot into standby firmware.

Accepted Solution

  • PeterUK
    PeterUK Posts: 4,415 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited June 2024 Answer ✓

    its

    cmd firmware boot-number 1
cmd firmware boot-number 2

All Replies

  • PeterUK
    PeterUK Posts: 4,415 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited June 2024 Answer ✓

    its

    cmd firmware boot-number 1
cmd firmware boot-number 2
  • bbp
    bbp Posts: 70 image  Ally Member
    First Answer First Comment Friend Collector Sixth Anniversary

    Thank you Peter. That works.

    Answer to my question number one is similar: cmd firmware boot-option 1

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）