VTI bootup causes VLAN to fail

Options
PeterUK
PeterUK Posts: 4,264 image  Guru Member
250 Answers 2500 Comments Friend Collector Eighth Anniversary
in USG FLEX H Series

USG FLEX200H V1.21(ABWV.0)

P4 VLAN47192.168.255.39 255.255.255.240

VTI Route-based

IP 192.168.254.9

Pre-Shared Key 12345678

Phase 1 AES128 SH256 DH2

Phase 2 AES128 SH1 DH2

VTI IP 192.168.255.42 255.255.255.240

Nailed-up

On bootup clients onVLAN47 have no internet ping to 1.1.1.1 fails

workaround go to network > interface > advanced setting disable/enable the VTI

Also uptime might be a problem

Accepted Solution

  • PeterUK
    PeterUK Posts: 4,264 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    Answer ✓

    Odd testing again its not doing this must of not waited after boot shows good long enough

All Replies

  • PeterUK
    PeterUK Posts: 4,264 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    Answer ✓

    Odd testing again its not doing this must of not waited after boot shows good long enough

  • Zyxel_Kay
    Zyxel_Kay Posts: 1,279 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - WLAN Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security

    Hi @PeterUK

    We would like to check if the issue still occurs.

    If you need further assistance, please let us know.

    Kay

  • PeterUK
    PeterUK Posts: 4,264 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary

    I think it was a case of the flex shows as ready LAN client gets a IP ping fails for a minute then works

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）