[NEBULA] When I add a device can I import the existing configuration to the site?

smrbrts
smrbrts Posts: 11  Freshman Member
First Comment Friend Collector Second Anniversary
edited April 2021 in Nebula
I've manually setup two NWA1123-AC Pro access points, and would like to add them to Nebula if I can import the existing configuration of one and use it for the other? Is this possible? Or when I register a device do I have to start from scratch reconfiguring?

Accepted Solution

All Replies

  • smrbrts
    smrbrts Posts: 11  Freshman Member
    First Comment Friend Collector Second Anniversary
    Too bad. Now I'm not sure I want to use it. Everything is running fine, but I use MAC filtering and VLANs and I'm not sure I want to configure it all again to use Nebula.
  • smrbrts
    smrbrts Posts: 11  Freshman Member
    First Comment Friend Collector Second Anniversary
    Given that we can save the config file, an import feature wouldn't have been unreasonable.
  • Zyxel_Barney
    Zyxel_Barney Posts: 84  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - WLAN Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Security
    edited September 2018
    Hello @smrbrts

    I agree that it is a reasonable feature. But as I have said before, the command structure of the two platforms are different. Commands made in NCC must always reflect the device's running configurations. For this to work, an extensive error-checking must be done during the configuration conversion process. 

    However, we can improve minor functions like importing MAC Filtering list to better support the migration from standalone mode to cloud mode. This, we can try adding to the ideas section.

    Regards,
    Barney Gregorio
  • CecilWard
    CecilWard Posts: 11  Freshman Member
    First Comment Fifth Anniversary

    I would need to import my large L2_isolation lists. I don’t think I’m going to go for Nebula.

Nebula Tips & Tricks