XMG1915-10EP - POE / PD is interrupted when booting

mparka · September 25

Hi, I have noticed, that switch when booting is performing 2 or 3 restarts of POE (power delivery is interrupted and resumed).

I would like to ask - is there any way to avoid such a situation? This is unfortunately causing that some of my SBCs etc. devices are powered up and forcibly powered off, then powered up, and again…

Of course this may lead to data loss etc. or some problem with hardware itself.

If currently it is not possible - then maybe some feature request - "delay power on after boot". I mean - option that POE is enabled only when switch is 100% booted-up.

Please consider and thank you.

regards,

Marcin

Zyxel_Melen · October 3

Hi @mparka,

We have found a solution for this issue, which will be fixed in the next firmware release. The ETA is the end of December.

mparka · October 3

Thank you very much.

Zyxel_Melen · September 26

Hi @mparka,

I understand your concern about the power interruptions during the XMG1915-10EP boot process. I'm checking with our team if there is a solution and I will keep you posted.

mparka · September 30

Thank you @Zyxel_Melen - I will wait for a solution/suggestion if any appears from Zyxel team.

Zyxel_Melen · October 3

Hi @mparka,

We have found a solution for this issue, which will be fixed in the next firmware release. The ETA is the end of December.

mparka · October 3

Thank you very much.

XMG1915-10EP - POE / PD is interrupted when booting

Best Answers

All Replies

Categories

Switch Help Center