Delay after reboot for some routing rules to enable

PeterUK · October 7

USG FLEX200HV1.21(ABWV.0)ITS-24WK35-m5760

Seems you have to wait around 5 minutes + after boot lets you login for some routing rules to apply mainly any with incoming set to any

bbp · October 7

https://community.zyxel.com/en/discussion/26250/delay-after-reboot-for-some-routing-rules-to-enable

Yes, from my observation, boot times have steadily increased since 1.10. H series doesn't boot faster than previous models, contrary to what Zyxel advertised.

HUBERT_KASPRZAK · October 8

Check the log on the USB to see if you have over 50,000 entries

, , , warn , user , two-factor auth. , , , , Two-factor Auth. daemon: uam_read_event error, ret = -1

Zyxel_Melen · November 1

Hi @PeterUK,

May I know if this issue still occurs after you upgrade to the latest date code firmware?

Hi @bbp, @HUBERT_KASPRZAK,

Is the FLEX H reboot still slow after upgrading to 1.30? If yes, can I request your configuration to reproduce and check this issue?

PeterUK · November 1

Its not so bad now but when SYS stays on you still have to wait a bit for the rules to apply about 60 seconds

bbp · November 1

https://community.zyxel.com/en/discussion/comment/71300#Comment_71300

In 1.21 it took an extra 5 minutes to load NAT rules. 1.30 seems OK.

Delay after reboot for some routing rules to enable

All Replies

Categories

Security Help Center