Virtual ethernet interface
I created a virtual interface on Lan1 (lan1: 1) to manage some devices on the network. Now, this interface has priority over client web authentication, the firewall login page is shown on the ip of lan1: 1
I think it's a Metric problem but it's not possible to set up.
How can I set priority to lan1 in the presence of a virtual interface?
0
All Replies
-
Virtual interfaces add extra addresses to the USG itself; if you are trying to send traffic to a device other than the USG, you may wish to setup a NAT virtual server instead.
0 -
this happens: on lan1 I activated Web Authentication and I created a virtual interface with ip 10.10.0.0; Client from lan1 is now proposed to authenticate on the USG on ip 10.10.0.1How can I bring authentication to 192.168.1.1?I thought it's a metric priority ..0
-
@A_Arienzo
You need to create the subnet address test(10.10.0.0, 255.255.255.0), and Go to web authentication> Create the rule Source:test, Destination: any, Authentication: unnecessary. This rule need to be first priority.
Charlie
0
Categories
- 6.8K All Categories
- 1.4K Nebula
- 29 Nebula Ideas
- 35 Nebula Status and Incidents
- 3.9K Security
- 200 Security Ideas
- 723 Switch
- 30 Switch Ideas
- 598 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 98 Service & License
- 214 New and Release
- 38 Security Advisories
- 510 FAQ
- 235 Nebula FAQ
- 117 Security FAQ
- 72 Switch FAQ
- Network Reliability
- Network Security
- IPTV
- Layer 3 Switching & Routing
- Surveillance / ONVIF
- Other Topics
- 65 WirelessLAN FAQ
- 5 Consumer Product FAQ
- Documents
- 30 Nebula Monthly Express
- 43 About Community
- 31 Security Highlight