VLAN From Draytek 2862 to GS1920-48HPv2

Options
Numberite
Numberite Posts: 1 image  Freshman Member
edited August 2022 in Switch
I am attempting to use a Draytek 2862 to send VLAN tags to a new GS1920-48HPV2. I have set per the guide and a number of suggestions from the web. I have set as one VLAN range but cannot get working. In reality I would like to use combined tagging, IE use one cable from router to Switch, with multiple VLAN's but after 8 hours I am not getting anywhere. Can you advise if it is possible to use a Draytek and switch, And if combined Tagging is possible.

All Replies

  • Zyxel_Lucious
    Zyxel_Lucious Posts: 283 image  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 1 - Nebula 25 Answers
    Hi @Numberite

    Welcome to the Zyxel community!

    For starters, our switch GS1920v2-48HP can support VLAN tagging.
    Let's have an example with Draytek 2862 configured as below 

    Configuration for GS1920v2-48HP:
    1.
    You should set whatever port which is connecting to router's P2 to be tagged-out, and fixed in VLAN 10, 11, 12.
    2.
    As for the ports that link to clients (such as PC), should be set untagged-out, and also fixed in VLAN 10, 11, 12.

    You can find attached Handbook in chapter 2.1 How to configure the switch to separate traffic between departments using VLAN & 2.2 How to configure the switch to route traffic across VLANs for configuration instruction in detail.

    Hope it helps.
    Zyxel_Lucious

Categories

Switch Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）