FLEX100H: Error: Command Failed on Activating Route Based ipSec VPN

szn
szn Posts: 20  Freshman Member
First Comment Friend Collector
in USG FLEX H Series

An error is showed up after Activating/starting a ipSEC VPN:

Posnetek zaslona 2024-12-25 184249.png

A Route-Based Site-Site VPN is created using wizard.

A VPN is showed as Connected. However traffic does not flow through.

Any idea?

Accepted Solution

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,177  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    Answer ✓

    Hi @szn ,

    Thank you for your remote session.

    Per our private discussion, firmware version 1.31P0 includes a fix for the issue you reported.

All Replies

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,177  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula

    Hi @szn ,

    To investigate the issue further, we need to access your USG FLEX 100H. Please check the Community inbox for instructions on enabling WAN access for our team. Thank you.

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,177  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    Answer ✓

    Hi @szn ,

    Thank you for your remote session.

    Per our private discussion, firmware version 1.31P0 includes a fix for the issue you reported.

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）