DHCP and Secondary IP

PeterUK · January 13

It CAN be possible older models do it!

when you do a routing rule

incoming LAN

next hop WAN 2

SNAT outgoing-interface which will be the the DHCP IP

Or in my setup also

incoming WAN to Secondary IP 192.168.254.1

Source Address 192.168.252.0/23

next hop WAN 2

SNAT outgoing-interface which will be the the DHCP IP

with Static route

192.168.252.0 255.255.254.0 gateway 192.168.254.2

Zyxel_Judy · January 16

Hi @PeterUK ,

To better assist you, please provide the following information:

Which firewall model do you need this routing function for?
What is your specific use case or business requirement for this routing function?
You mentioned that some models already support this function. Could you:
- Specify which model(s)
- Share a screenshot of the existing configuration

PeterUK · January 16

Its the FLEX200 H and on a early version of the firmware it was possible see case #456511

The specific use case was that it worked and I used it and now have had to set it up another way which means a extra port was needed

It was done on a Zywall 110 which was replaced for more testing with FLEX200 H

Zyxel_Judy · February 4

Hi @PeterUK ,

Thank you for your interest. We are still evaluating this feature. We will announce it in our Firewall News & Release section if it becomes available in the future.

DHCP and Secondary IP

Active · Last Updated January 13

Comments

Categories

Security Help Center