FWA505 bridge mode

Options
MattiS
MattiS Posts: 9 image  Freshman Member
First Comment Friend Collector
in Home Router

Hello!

How do I put the wan port in bridge mode, so that the firewall gets the ip address straight from isp?

All Replies

  • Peter2
    Peter2 Posts: 176 image  Master Member
    5 Answers First Comment Friend Collector First Anniversary

    You can change in the braoadband section from Routing to bridge mode if your firmware is not provider restricted and allows this . The rest is to configure your firewall device behind the router to set up the connection .

  • PeterUK
    PeterUK Posts: 4,422 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited April 2025

    Use Cellular IP Passthrough

    note some Cellular providers don't give you the WAN IP and or by CGNAT

  • Peter2
    Peter2 Posts: 176 image  Master Member
    5 Answers First Comment Friend Collector First Anniversary

    Nearly the same according to this article :

    https://support.zyxel.eu/hc/en-us/articles/360021412820-NR7101-FWA710-How-to-set-bridge-mode-cellular-IP-passthrough

    "Bridge mode is also called cellular IP passthrough on many Zyxel LTE devices. This article will teach us how to set your NR7101 / FWA710 to bridge mode.

    Please note that the default mode will be "Routing Mode / NAT Mode.""

     

Categories

Consumer Product Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）