no link in P1 port, in Flex200H device

AdminSys
AdminSys Posts: 30  Freshman Member
First Comment Seventh Anniversary
in Security

Our company has a Flex200 firewall, and the service provider device is FiberHome AN5506-02-FG GPON Modem Router (configured PPPoE connection). We receive a Flex200H device for testing, to which, if we replace our own device, there is no link on anymore the WAN (P1) port
It is plugged into any other device there is physical link , but not in the service provider router.
What is the problem, do I need to configure something?

All Replies

  • PeterUK
    PeterUK Posts: 3,750  Guru Member
    100 Answers 2500 Comments Friend Collector Seventh Anniversary
    edited April 29

    So PPPoE is setup in the FiberHome AN5506-02-FG GPON Modem Router to which your just dealing with Ethernet from it? or do you need to setup PPPoE on FLEX?

    You can setup WAN on any port so test on the 1Gb ports

    Does P2 do the same? try setting link speed.

    if you double NAT does P1 work?

    If you get a 2.5Gb switch between the links does that work?

  • AdminSys
    AdminSys Posts: 30  Freshman Member
    First Comment Seventh Anniversary

    AN5506-02-FG GPON Modem Router is in bridge mode, pppoe is configured in Flex.

    set this port to 1GB - does not change

    plug to P2 - does not change

  • Zyxel_James
    Zyxel_James Posts: 699  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate 100 Answers

    Just to clarify, do you mean that the PPPoE session is not establishing, or is the physical connection not coming up?
    does the port LED blink?

  • AdminSys
    AdminSys Posts: 30  Freshman Member
    First Comment Seventh Anniversary

    port led is not blinking - physical connection not coming up

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）