XGS2220 VPLS routing

oliversolman
oliversolman Posts: 4  Freshman Member
First Comment
in Switch

Hi all, we are trying to route XGS switch which is 10.7.1.7 0.0.0.0/0.0.0.0 to 10.7.1.4 but fail on adding route. We where told we should be able to do this but when we try to add route is tells us its invalid syntax. Does anyone has any suggestions? We trierd Nebula and standalone with no luck.

All Replies

  • Zyxel_Judy
    Zyxel_Judy Posts: 2,201  Zyxel Employee
    Zyxel Certified Network Engineer Level 2 - Nebula Zyxel Certified Network Engineer Level 2 - Switch Zyxel Certified Network Engineer Level 2 - Security Zyxel Certified Network Engineer Level 1 - Nebula
    edited 3:40AM

    Hi @oliversolman ,

    To better assist you, please provide the following information:

    1. What is the VPLS routing configuration in this case?
    2. What is the intended purpose of this configuration?
    3. We realize that 10.7.1.7 and 10.7.1.4 are on the same subnet, so there is no need to add a route to allow the traffic to flow. So, what are the source and destination IP addresses, devices, and the positions they are placed?
    4. How did you configure Standalone mode? Please include screenshots of your configuration and any invalid syntax messages.

Categories

Switch Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）