Is there an issue with the guest wifi working on the usg20w-VPN with firmware version 4.33(ABAR.0)?
Options
Freshman Member
I am setting this brand new FW and the wizard said it was successful in easy mode but there is no internet connection. I found a KB and followed steps to set up a policy to allow it but that did not work either.
The main wifi connection has worked from the start after a NAT rule was setup because the ISP modem is bridged over to this FW.
The main wifi connection has worked from the start after a NAT rule was setup because the ISP modem is bridged over to this FW.
0
All Replies
-
Resolved by going to Configuration > Interface > Ethernet (tab) and changing the Guest configuration zone to Guest.0
-
0
Zyxel Employee
Categories
- All Categories
- 440 Beta Program
- 2.9K Nebula
- 208 Nebula Ideas
- 127 Nebula Status and Incidents
- 6.4K Security
- 528 USG FLEX H Series
- 331 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.3K Wireless
- 50 Wireless Ideas
- 6.9K Consumer Product
- 292 Service & License
- 462 News and Release
- 90 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.6K FAQ
- 34 Documents
- 86 About Community
- 99 Security Highlight
