Flex H Models Routing Protocols e.g. BGP

But, here is another annoyance. Here are some console settings that are NOT on the web interface:

running network-stack# conntrack
<return> Validate command.
| Add an output modifier.

icmp-timeout Range: 1..300.
Conntrack ICMP timeout.
icmpv6-timeout Range: 1..300.
Conntrack ICMPv6 timeout.
max-entries Range: 16..10000000.
Maximum number of Netfilter conntracks.
tcp-timeout-close Range: 1..300.
Conntrack TCP timeout close.
tcp-timeout-close-wait
Range: 1..300.
Conntrack TCP timeout close wait.
tcp-timeout-established
Range: 1..432000.
Conntrack TCP timeout established.
tcp-timeout-fin-wait Range: 1..300.
Conntrack TCP timeout fin wait.
tcp-timeout-last-ack Range: 1..300.
Conntrack TCP timeout last ack.
tcp-timeout-max-retrans
Range: 1..600.
Conntrack TCP timeout max retrans.
tcp-timeout-syn-recv Range: 1..300.
Conntrack TCP timeout syn recv.
tcp-timeout-syn-sent Range: 1..300.
Conntrack TCP timeout syn sent.
tcp-timeout-time-wait
Range: 1..300.
Conntrack TCP timeout time wait.
tcp-timeout-unacknowledged
Range: 1..600.
Conntrack TCP timeout unacknowledged.
udp-timeout Range: 1..28800.
Conntrack UDP timeout.
udp-timeout-stream Range: 1..28800.
Conntrack UDP timeout stream.

These are important settings in at least some cases, where sessions need to be open longer, so these need to be adjusted.

What i cannot find are the default settings, as they are not visible in the running - but please enlighten me if there is a command to show ALL the config , even with the default values.

There is this UPS software where delivery/pickup orders are uploaded via https.

But the response is slow and it looks like it is running into a TCP timeout on the Firewall side, while the UPS website is keeping the session open which ends up in "blocked" messages in the firewall log and a failed upload.
I had something like this on other firewalls and adjusting the half open sessions to a longer timeout.
But without knowing the default values, it is difficult to figure out what to adjust.