Permanent banner for scheduled regular upgrade

GiuseppeR · September 13

Hello everyone,

during these days if you enter an ORG with a SCR50AXE that is planned to be upgraded, you see this banner:

The problem is that it remains there also when you change to another ORG with 60 LITE or Flex just updated to latest firmware.

If you click on its X to close it, and then you go to another SCR50AXE ORG you cannot see it again also if that ORG needs firmware update.

That's strange 😁

Zyxel_Melen · September 16

Hi @GiuseppeR

Thanks you to point this out. This could be an issue when change org. I can replicate this issue and we are investigating it. I will keep you updated.

GiuseppeR · September 25

Hi @Zyxel_Melen

I have the same bar:

Also going from one ORG that has a Flex 200H to be updated to another one where everything is up to date, as you can see below:

Zyxel_Melen · September 25

Hi @GiuseppeR

Thanks for the further information. We have addressed this issue, and the fixed schedule is set for December. I will update here if the fix is done.

Permanent banner for scheduled regular upgrade

All Replies

Categories

Nebula Tips & Tricks

Nebula Help Center