MSP portal supports to display the alert status of the devices
Zyxel Employee
User @nielsscheldeman requests that MSP portal should support to display the alert status of the devices. The alert status represents the device has "10/100Mbps link speed", and other organe/alert status from the device status.
Anyone likes this idea, please leave you comment below and give it a vote.
Comments
-
Also why it would be handy is because of this: I had a customer this week that reported me, that they couldn't connect to wireless in 1 production room. After logging in to their specific site, I saw that it was running on low power mode(NWA130BE, this AP support 802.3af, but the radio's will be turned off then, which is also pretty stupid, what is the use of the AP then, would be better if it didn't turn on at all), because of an old switch.
If MSP Portal would show warnings too, I would have seen it before my client noticed.
0
Ally Member
Categories
- All Categories
- 442 Beta Program
- 2.9K Nebula
- 221 Nebula Ideas
- 128 Nebula Status and Incidents
- 6.5K Security
- 610 USG FLEX H Series
- 347 Security Ideas
- 1.7K Switch
- 84 Switch Ideas
- 1.4K Wireless
- 53 Wireless Ideas
- 7K Consumer Product
- 299 Service & License
- 483 News and Release
- 92 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.8K FAQ
- 34 Documents
- 88 About Community
- 105 Security Highlight
