How I can setup the DHCP on USG 1100. Firmware 4.33(AAPK.0)

Options
iojeda
iojeda Posts: 4 image  Freshman Member
First Comment Third Anniversary
edited April 2021 in Security

I'm , new on the Zyxel world, I had almost a month try to make work the USG 1100, so far I was able to make the VPN connect but not traffic in and out then I notice that my DHCP is not leasing IP address to no one. If so one can help me to figure this out I will really appreciated.

All Replies

  • Zyxel_Stanley
    Zyxel_Stanley Posts: 1,436 image  Zyxel Employee
    100 Answers 1000 Comments Friend Collector Eighth Anniversary

    Hi @iojeda  

    In default configuration Ge3~Ge5 have enabled DHCP server function.

    Configuration > Network > Interface > edit interface configuration setting.

    3.png

    According to VPN question, system will auto route traffic in the VPN tunnel when traffic SourceIP/DestinationIP are the same as LocalPolicy/Remote Policy in VPN setting.

    Does your traffic has match to this condition?

    4.png
  • iojeda
    iojeda Posts: 4 image  Freshman Member
    First Comment Third Anniversary

    Thanks for the answer the issue was the firmware, After reset to factory the DHCP start tu issue IP address.

  • Zyxel_Stanley
    Zyxel_Stanley Posts: 1,436 image  Zyxel Employee
    100 Answers 1000 Comments Friend Collector Eighth Anniversary

    Hi @iojeda

    It's good to know the issue has resolved in your environment.😁

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）