cannot access nas326 via web browser.

makavell · May 25

So i changed my router and setup the ip of the nas to 192.168.0.100 but i cannot access it via the web browser. the nas seeker utility also doesnt see the nas. NAS_Starter_Utility_NSU_2.1.2.15.0831_build_1065

i reset the nas several times. i remember i had to put like 8080 but i still wont open. i can map the network drive and access all my files but I cannot access the nas. the reason is i want to install entware on it.

i tried

http://nas326/

http://findme.zyxel.com

Any ideas??? much appreciated.

i already enabled smd 1.0 file sharing and direct

ariek · May 30

Have you tried to logon to your router? Check which devices are connected to the router. If the NAS is connected, it will be listed there. Make a note of the IP address and the MAC address. The NAS will be accessible at the listed IP address.

Consider having the router assign a static IP address to the NAS, so that it can always be reached at the same IP address.

shv · August 18

Results of Copilot (AI):

To reset your Zyxel NAS326, use a paperclip to press the physical RESET button on the back. A single beep (after 2 seconds) resets the IP address and password to admin / 1234. Two beeps (holding longer) restores factory defaults. Neither option deletes hard drive data.

cannot access nas326 via web browser.

All Replies

Categories

Consumer Product Help Center