-
supervisor/root and admin password of my NR7303
Hello, I'm need the supervisor/root and admin password of my NR7303. S/N is S240Z29003300 Can someone help me please? Many thanks.
-
LTE5398-M904 don't see band 1 of TIM (Italy)
Hello, as mentioned by other users, the current LTE Module Version: EG18EAPAR01A12M4G , does not see the band 1 used by TIM (one of the main Italian ISP). Can you provide the file to downgrade to the EG18EAPAR01A08M4G ? Multiple users confirmed that the previous revision is free from this defect. Thanks.
-
NR7101 working with vlans throught LAN interface
Please, I want your help. I have the Zyxel NR7101 5G with ip-passthrough. I want to get Zyxel ip from my router via VLAN (e.g vlan ID30) as a DHCP client. Is it possible? If it's not working as a DHCP Client is there any solution to get an ip via VLAN from router?
-
Problem with NR5103EV2 device
Model Name NR5103EV2 Firmware Version V1.00(ACIR.1)C0 With it, there’s the following problem, with the following symtomatics. For example, there was a network on LAN 192.168.1.0/24 addresses of Router 192.168.1.1 , on WAN Cellular Hung address 192.168.1.2 (what is it? start problems. packet loss.) change to LAN on…
-
The LTE7490-M904 needs more than one minute to reconnect the cell?
The wind tower disconnect the router every four hours. This happen also with my mobile phone, but the mobile phone reconnect again in a few seconds. Instead the LTE7490-M904 needs more than one minute to reconnect the broadband… If I am in a zoom call, it's a pain. Thank you
-
NR7101 - setup instructions to WAN port on UniFi Dream Machine
hi all, I have just got a NR7101. I have inserted the SIM card and can see it’s connected, the light on the NR7101 is Green. I can connect to the WiFi and configure the device. I have it plugged into the PoE injector that came with the device, so all good so far. I have plugged a cat6 cable from the injector to the WAN…
-
How to set the static Ip between Zyxel NR7302 and access point Tplink.
Hello, I try to set the static IP first in " Home Networking" after in the " routing" section but nobody of this is correct. The Zyxel is setting automatically other Ip like 10.208.233.40. Do you know how to set correctly? Thanks
-
Receive NAK from DHCP server NR7101 to my router
I have NR7101 with ip-passthrought, 2 apns first the default and second VLAN interface. So my router take the 2 ips from NR7101 but the problem is my dhcp client drop the connection from release/renew and receive NAK from DHCP. There is 1,5 sec period time for this check so drop my connections when change the ips. Why this…
-
NR7102 - Set eth1 interface speed manually
Hi, Is there possibility to set the eth1 interface speed manually? Getting following in the logs even if the up level switch is fixed 1Gbsp (about 10sec in the logs) esmd: Interface: eth1, Status: Down esmd: Interface: eth1, Status: Up, Speed: 1000, DuplexMode: Full esmd: Interface: eth1, Status: Down esmd: Interface:…
-
NR7302 - without password sticker - Zyxel really this bad?
@Zyxel_AL Dear Zyxel, a lot of users bought the NR7302 second hand and on some units the password sticker is entirely missing. Zyxel denied any support so far for such units because they are "carrier provided". You don't have to provide hardware guarantee. But do you really want to be seen as a company who does not help…
-
Request for NR5103V2 Latest Firmware (Linked from Zyxel security advisory CVE-2024-5412)
Hi, I was browsing to find solutions for the problems I had with my NR5103V2 lately, including: Slow connections when browsing the web and downloading files( less than 0.5 mb/s), while on the other hand speed test result seem otherwise! Unable to connect ipv6, moreover I saved a copy of configuration with the setup I had…
-
[NR7302] IP passthrough not working
I'm running the device on 1.00(ACHA.4)b5_F0 and it's connected to the Telekom network in Germany. I'm trying to get IP passthrough working correctly. So I connected it to a dedicated port on a OpenWRT router and IP passthrough is set to dynamic mode. I can see that the mode is enabled and the device even shows the…
-
Missing Password Sticker on Zyxel NR7302 - Any Solutions?
Hi everyone, I recently bought a Zyxel NR7302 5G NR router on eBay, but unfortunately, the sticker with the default password is missing. Without it, I’m unable to access the router’s interface. Does anyone know if it’s possible to replace or recover the password in this situation? Maybe a way to reset the router or contact…
-
NR7302 firmware upgrade
Hello i tried to make a firmware upgrade for my NR7302 5g broadband and the automatic update is not working. Where can i find the firmware to download it?
-
not receiving sms on lte 3316-m604
so in the begining i was able to read and sent sms, but for some reason history of sms was deleted and im not able to receive or sent any sms, tried to reseting to factory settings but it didnt help
-
NR7123 Can't connect to Zyxal Air App
Hi, I just got a NR7123 and it doesn't connect to Zyxel Air app, I've tried 3 different Android phones, the web gui works fine and can login as Admin, but app says it can't find the modem. Another weird behaviour is when connected to the modem's wifi the internet doesn't work, only via cable, I've factory reset multiple…
-
Wo kann ich die FW für NR7101 laden
Wir suchen für den Router NR7101 die Firmware V1.00(ABUV.11)C0
-
NR5103 recovery options no web interface
During a firmware update, there was a power cut. The NR5103 web interface won't come back up. Is there any way of recovery via USB, TFTP or?
-
NR7302 Supervisor/root and admin Password
Hello, I'm need the supervisor/root and admin password of my NR7302. S/N is S240Z19005293 thx
-
NR5103 power cut during firmware update
As title. During a firmware update, there was a power cut. The NR5103 web interface won't come back up. Is there any way of recovery via USB or TFTP? I know the firmware is available for direct download from support pages