-
Resetting a NR7101 Router
Hi. I have a NR7101 which was bought through my ISP. I have cancelled this ISP for another cheaper vendor but still wants to use this router. My ols ISP whivh have configured my router an locked it to them says I cant change my self. Does anyone know how I ca reset it, so that I am able to use with an other vendore SIM…
-
Anyone running OpenWrt?
I'm curious to know whether anyone else is running OpenWrt on their Zyxel router or on a dedicated downstream router? OpenWrt gives many benefits, but I think the most significant benefit is the facilitation of bufferbloat mitigation using the CAKE algorithm, which keeps latency in check during heavy usage. Bufferbloat…
-
Firmware for VMG8029 and custom mapping
Hi, is there any way to get the latest firmware for VMG8029? I tried searching for it but i couldn't find anything. I also would linke to set a custom VoIP service mapping other than the 6 specified. Is there any chance of achieving this? Thanks.
-
NR7101 - Update and Troubleshooting Instructions.😒
Note: We recommend avoiding LTE (radio) module firmware updates unless necessary, as they can sometimes reduce device performance. LTE (radio) is often tailored to specific regions and network settings. If your device is stable, updating the device firmware only, not the LTE module, is sufficient. Open link and scroll down…
-
FWA505 Looses internet connection and needs rebooting
Hi. My router looses internet connection 2-3 times a day and I need to reboot it to get connection again. WIFI and 5G signal is fine. Tried different SIM Provider and also moved the router around to different locations, but issue is still there. Any one experiencing this? Log keeps writing this below. What does it mean?…
-
FWA710 scheduled reboot
Hi, could you add a scheduled reboot option to the firmware of the FWA710 as you did with the NR7101? https://community.zyxel.com/en/discussion/comment/47134/#Comment_47134
-
NR7101 disconnecting
Good morning. I tried opening a ticket for my issue, but the page wouldn't load after writing my router's Serial Number. I'll try to ask here. I recently bought an outdoor router NR7101, that is currently placed on my roof with inside a SIM card. From there, the ethernet cable goes through my home and inside the POE…
-
NR5101 latest firmware upgrade and Module Upgrade
Hello Folks, I have done a firmware upgrade on my NR5101. I have done it through the Online Firmware Upgrade to following Firmware : V1.00(ABVC.9)C2. So far so good. However It does not seems to be latest recommended. Can you confirm if I should rolled back to ABVC.6C0 or keep the ABVC.9C2 ? Also my module firmware is…
-
NR7101 - Help me figure our why my 5G is so slow...
TLDR; my NR7101 reaches 113/44 MBit/s while my phone, at the exact same location, reaches > 785/125 MBit/s. Why? NR7101: 1.00(ABUV.10)C0 and RG502QEAAAR13A02M4G (waiting on the other thread to land somewhere on upgrading model to A04, but all previous modem versions had the same issue) Bridge mode, disabled UMTS, Preferred…
-
NR7101 - Downgrade R13A04 to R13A02
Hello Everyone Here on the forum several files have been shared that allow incremental downgrades such as: "RG502QEAAAR13A02M4G-RG502QEAAAR11A07M4G" and "RG502QEAAAR11A06M4G-RG502QEAAAR11A03M4G" it's possible to have also the downgrade: "RG502QEAACR13A04M4G_ZYXEL-RG502QEAACR13A02M4G_ZYXEL" ? It would be very important to…
-
Having trouble to get NAT working
Hi. I've got a FWA710 in router mode and can't access my network via port forwarding (NAT). I've set up the NAT page like this Ive tried to cange WAN-interface to default but no success. Firewall are set to low. I've rebooted several times. Any clues on what I've set up wrong? Thanks for any help Jonny
-
IP Passtrough with German Telekom and Ubiquiti Dream Machine
Hello, I'm starting to feel at a loss. I would like to use the LTE5398 as a modem for the Dream Machine. To do this, I activated IP passthrough and deactivated all NAT settings. So far so good. I can still access the Internet via the Dream Machine. I would like to play on the go using my Xbox Remote. This requires UPNP,…
-
Ako získam heslo správcu do zariadenia
Zariadenie typu NR7103 , SN / S220Z41006523 nefunguje s prednastaveným heslom zo štítku, ako môže získať heslo správcu prosím..
-
Latest Firmware for lte3316-m604-v1-00
Where can I find latest Firmware for my lte3316-m604 v1.00
-
NR5101 loses internet connection when getting a call
When the SIM card in my NR5101 is getting a regular voice call, it most of the time loses internet connection. It doesn't loose cell coverage, the whole router just stops connecting to the internet and it also doesn't reconnect when the call is over. It's a multi SIM setup with 2 SIM cards working at the same time. One in…
-
LTE3316-M604 V1.00 firmware
Where can I find latest firmware for the V1.00? I have V1.00(ABMP.3)b2
-
NR5103 Request for update firmware stuck to version V4.19(ABYC.3)C0 released more than 1 year ago
I ask for an update for the firmware of this router. It's not possible that it is stuck to an old firmware without improvements, such cell lock and bug fixes.
-
Finally nr7101 Firmware V1.00(ABUV.10)C0
I saw something strange when doing a scan… MNC, MCC?
-
LTE3316 - no support for IPv6+NAT64 without DNS64
Router: Zyxel LTE3316 with firmware V1.00(ABMP.2)C0Mobile carrier: Free Mobile (France, 13+ million customers)* single stack IPv6 APN * NAT64 using custom prefix 2a0d:e487:ffff * carrier's DNS servers (2a0d:e480::1 and ::2) do not perform DNS64 * NAT64 prefix discoverable through RFC7050 (=lookup of ipv4only.arpa) Issue:…
-
NR5103EV2 - IP-Passthrough menu setting is missing
Hi! we are having issues with a menu missing in web gui on a Zyxel NR5103EV2-model. No firmware updates available and multiple resets on the router. We want to use this as a modem and passthrough WAN IP to another firewall/router. Has the "Cellular IP-Passthrough" menu been moved to another place?