NR7101 No access to WAN using WiFi...

Bamse
Posts: 5
Freshman Member


Hi,
After a factory reset I am no longer able to connect to any WAN sites using a WiFi connection to my NR7101. Cabled connection works just fine. It is probably just something obvious I have missed, but cannot seem to figure out what it is.
Thanks!
After a factory reset I am no longer able to connect to any WAN sites using a WiFi connection to my NR7101. Cabled connection works just fine. It is probably just something obvious I have missed, but cannot seem to figure out what it is.
Thanks!
0
Accepted Solution
-
Hi Bamse,
Refer to the product description, "WiFi interface is used for local management purposes only."
https://www.zyxel.com/products_services/5G-New-Radio-Outdoor-Router-NR7101/specifications
Regards,
Bob1
All Replies
-
Hi Bamse,
Refer to the product description, "WiFi interface is used for local management purposes only."
https://www.zyxel.com/products_services/5G-New-Radio-Outdoor-Router-NR7101/specifications
Regards,
Bob1
Categories
- All Categories
- 434 Beta Program
- 2.7K Nebula
- 172 Nebula Ideas
- 117 Nebula Status and Incidents
- 6.1K Security
- 405 USG FLEX H Series
- 296 Security Ideas
- 1.6K Switch
- 78 Switch Ideas
- 1.2K Wireless
- 43 Wireless Ideas
- 6.7K Consumer Product
- 268 Service & License
- 413 News and Release
- 87 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 83 Security Highlight