Migration path from NSG to USGFLEX/ATP

MartyWalter
Posts: 32
Freshman Member



Updating from an NSG device to a USGFLEX or ATP device is a time consuming process. It requires you to remove the NSG Device from Nebula before you can add the USG lflex or ATP device. It does not seem to carryover any of the programming such as security policies interface addresses etc.
it would be great if there was a migration path to simplify this process. As the older NSG devices go to end of life we will be needing to upgrade more and more.
it would be great if there was a migration path to simplify this process. As the older NSG devices go to end of life we will be needing to upgrade more and more.
2
Comments
-
Update - Still trying to migrate the customer from the NSG300 to an ATP700. Simply removing the NSG device and adding the ATP device does not work. When you do so, you receive a message 'This site had been used NSG300 on before, so can't be add NSG\NSG100\NSG200 into this site"
It does not seem possible to migrate.
0
Categories
- 8.4K All Categories
- 1.6K Nebula
- 70 Nebula Ideas
- 56 Nebula Status and Incidents
- 4.5K Security
- 226 Security Ideas
- 980 Switch
- 46 Switch Ideas
- 870 WirelessLAN
- 22 WLAN Ideas
- 5.1K Consumer Product
- 155 Service & License
- 280 News and Release
- 58 Security Advisories
- 13 Education Center
- 578 FAQ
- 261 Nebula FAQ
- 160 Security FAQ
- 76 Switch FAQ
- 74 WirelessLAN FAQ
- 7 Consumer Product FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 46 Security Highlight