How to register Access Point to Nebula






This article will show you the methods to register any Nebula-enabled Access Point (AP) into the Nebula platform by Nebula Mobile APP and Nebula website.
Note: * By the method, you can add all Nebula devices, not only APs.
Note: ** QR code, MAC address, and serial number from the device back label/sticker.

Part 1: Adding devices by Nebula Mobile APP
The Nebula Mobile App offers a quick approach to network management. It allows administrators to use the QR code scanner to register a large number of devices on Nebula Control Center all at once. Specially, you can register a device while the device is already registered to another Organization or Site.
After logging in to Nebula Mobile APP, go to the designated Organization/Site
1. Choose the Devices tab, and click the “Add Device” or “+” button.

2. Scan the QR code, click “Next” if this device has not been registered to another Organization or Site, or click “Register Device” and “Next” if this device is already registered to another Organization or Site.

3. Click Register 1 Devices. The number of devices shown there depends on how many devices you scanned the QR code before.

Verification:
Part 2: Adding devices to the Nebula website
Method 1: Adding devices on a single site (Site-wide)
Recommend using this method in the case there is a single site in your organization, you can add devices directly to the site. Note that the page has no option to remove devices from the site.
1. Choose your Organization and your Site
2. Go to Left Navigation Bar Devices >> click the "" button (Add devices) on the top right >> Click Add
3. Input MAC address and serial numbers of devices. Click Finish
Or click Add another device to input the MAC address and serial numbers of devices before clicking Finish.
Method 2: Adding device to multi-sites (Organization-wide)
Recommend using this method in case there are multi-sites in your organization. Go to License & Inventory page where you can add and view all Nebula devices currently operating under the organization. Devices can then be assigned or re-assigned to different Nebula sites created in these Nebula organizations.
Step 1. Adding devices to Organization-wide
1.1 Select your Organization.
1.2 Open License & Inventory >> Devices. Click Add.
1.3 Input MAC address and serial numbers of devices. Click Finish
Or click Add another device to input the MAC address and serial numbers of devices before clicking Finish.
Step 2. Assigning devices to Nebula sites
2.1 Click Action, then select Change Site Assignment
2.2 Select the site to add a device and click the Save button
Note: *** You also can add many devices to a site at the same time, and repeat the same procedure.
Note: ****Repeat the same procedure for other sites.
Verification:
Click this link to start: https://bit.ly/3R2Wx52
Judy
Categories
- All Categories
- 192 Beta Program
- 1.7K Nebula
- 93 Nebula Ideas
- 63 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 51 Switch Ideas
- 920 WirelessLAN
- 28 WLAN Ideas
- 5.4K Consumer Product
- 174 Service & License
- 296 News and Release
- 65 Security Advisories
- 14 Education Center
- 1K FAQ
- 453 Nebula FAQ
- 258 Security FAQ
- 100 Switch FAQ
- 115 WirelessLAN FAQ
- 22 Consumer Product FAQ
- 67 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 69 About Community
- 52 Security Highlight