Ethernet backhaul - Switch

Peter2609

I run 3 Multy M1 on a switch that is connected to my router (Fritz 7590AX) in the basement. The Multy M1 router is in the living room on the ground floor, the satellites on the first and second floor. The Fritzbox only establishes the Internet connection and assigns the IP addresses. Each Multy M1 is connected to its LAN1 port via an Ethernet cable. The Multy M1 system is configured for bridge mode.
Everything actually works, but the app shows that the devices are connected in series. Can this be ignored or is there a solution to optimize the mesh?

Zyxel_Jerry

Hi @Peter2609

Thanks for the feedback
We have noticed the issue and we're working on it.