How to config WAN trunk in NCC webpage

GiuseppeR

Hello,

I see that using USGFLEX500 is useful to set which RJ45 port is WAN or LAN.

Looking into its config inside "Site-wide > Configure > Firewall > Routing" I see where I could set the WAN for backup: here I have the problem to set a WAN trunk, I have a WAN1 as main connection, but I want to use as a backup the WAN2 + WAN3.

Where I can config this on Nebula?

Thanks in advance

Zyxel_Kevin

Hi @GiuseppeR ,

Greeting Forum, Please knidly below the tutorial, It guide how to set WAN backup on Nebula

https://community.zyxel.com/en/discussion/14281/atp-flex-how-to-configure-wan-load-balancing-on-nebula

Please feel free to contact us if any concerns.

Thank you

GiuseppeR

Hello @Zyxel_Kevin

thanks for the tutorial but I have WAN1, WAN2, WAN3.

I need that when WAN1 fails, both WAN2 + WAN3 go online.

It seems to me that my scenario is not as described in the tutorial.

Zyxel_Kevin

Hi @GiuseppeR ,

In general we will use Policy based route with Trunk interface when on-premise mode.

We don't support the kind of setting in Nebula so far.

We will continue enhace this part,

Thank you