[NEBULA] How to change location of my devices between different floor plan?
Comments
-
Hi JohnM
Welcome to our Nebula Forum. We have a detailed step-by-step information on FAQ to guide you how to update floor plans and distribute your devices among different floor plans. FAQ > Configurations > How to change a location of my devices between different floor plans?
The example is to upload two floor plans ZHQ A and ZHQ B at first then relocate a registered nebula device(ex:NSG100) from ZHQ B to ZHQ A. Besides, if your have more than one floor plans located in the same place, just click the "Floor plan" button on the top of the map, you will view categories of devices and device distribution among different floor plans. Last but not least, when you select one floor plan, the others will be invisible. Hope this has be useful and clear to you0 -
hey @Nebula_James
I did try the steps you mentioned in the FAQ and I was able to place my devices, but I would say that switching between Place device on map and Edit floor plans tabs is kind of odd.
Any plan of improvement about this?0 -
@JohnM
The behavior to change the device among different floor plans may not be intuitive and lack user-friendly. I will have an internal discussion about function improvement and PM to you if there is any update1 -
Thanks @Nebula_James , looking forward for good news0
Categories
- 6.8K All Categories
- 1.3K Nebula
- 26 Nebula Ideas
- 28 Nebula Status and Incidents
- 3.8K Security
- 199 Security Ideas
- 691 Switch
- 25 Switch Ideas
- 571 WirelessLAN
- 8 WLAN Ideas
- 4.5K Consumer Product
- 95 Service & License
- 213 New and Release
- 35 Security Advisories
- 479 FAQ
- 216 Nebula FAQ
- 109 Security FAQ
- 72 Switch FAQ
- 66 WirelessLAN FAQ
- Documents
- 20 Nebula Monthly Express
- 42 About Community
- 31 Security Highlight