USG40 problem VPN SecuExtender Tap-Windows Adapter V9

cantonim

Good morning, after the last firmware update to version 4.32 (AALA.0) C0 with SecuExtender client version 4.0.3.0 installed on windows 10, I encounter a client-side problem on the release of the IP to the Tap-Windows Adapter V9 adapter, as if a incorrect ip address. This causes the inability to enter the corporate network. The only way is to manually configure the IPv4 in Tap-Windows Adapter V9 thank you

jasailafan

You have the same symptom as that in the following discussion.

https://businessforum.zyxel.com/discussion/2196/ssl-vpn-with-secuextender-not-working

Workaround

- Set subnet in "Assign IP Pool" and the issue is resolved. 

https://businessforum.zyxel.com/discussion/2071/secuextender-4-0-3-0-for-windows-failed-to-access-zywalls-lan

Solution

- Wait for firmware 4.33.  

cantonim

thank you, I will try immediately